Are you looking to increase the speed and accuracy when cutting holes in plate steel, clean up the quality of the cut, or have you tried using a hole saw only to have it catch and "walk" across your work piece, effectively destroying your dash?
The SWAG knock out punches can effectively eliminate all the problems commonly associated with inexpensive hole saws. The SWAG knock out punches are capable of cutting up to .1875" aluminum and or .125" mild steel, .083" chromoly, & .083" stainless.
Made in the USA out of domestic steel. These knock out punch dies are CNC machined out of 4130 quenched and tempered chromoly steel then heat treated, hence their brownish/orange tint. Simply put, these punches are the highest quality dies that we can produce.
These knock out punches are pressed together using a 10 Ton Hydraulic Knockout Punch Driver as shown in the 2nd picture above. Not sure what one is? Check out Ebay or Harbor Freight, they sell for ~$100.00 shipped to your door step and they are a real time saver if you are dimpling a large number of items or hard to reach dimple die locations. It includes a manual hand pump to apply hydraulic pressure to the punch set. The knock out punch set is a quality product and we have dimpled thousands of holes for years using this set up.
The HF Knock Out Punch Set can be purchased for $90 HERE.
Please Note: We do not sell the hydraulic punch driver and or the Air/Hydraulic foot switch, they are shown in the image gallery for reference only. At this time we are not going to split up our knock out punches individually. The thread pitch on the knock out punch dies are a 3/4"-16 TPI.
Our 7 piece knock out punch set set shown HERE is designed to compliment the automotive knock out punches listed above.
Our 8 piece tube dimple die set shown HERE is designed to compliment our 7 piece knock out punch set.